monitor- modify monitor.fileList

Post any question you may have in regards to GoAnywhere Director and let our talented support staff and other users assist you.
2 posts Page 1 of 1

ernguyen

Posts: 11
Joined: Fri May 22, 2015 3:21 pm

Post by ernguyen » Tue Jun 09, 2015 6:05 pm
I'm working with my first monitor to trigger a project. The monitor checks for new files on an sftp resource every 4 hours. If a new file is found it will trigger project. I unknowingly had an problem with my project and as a result when 2 new files were discovered the project ran but failed.

Now it appears the snapshot considers these files as old. Since these files did not transfer as expected, is there a way to reset something so the monitor detects those two files?

My attempts to manually pass the file name through a project level variable was not successful (I think because I attempted to pass a single file name variable through on a source files variable).

All input welcomed, thanks

Support_Rick

Support Specialist
Posts: 592
Joined: Tue Jul 17, 2012 2:12 pm
Location: Phoenix, AZ

Post by Support_Rick » Mon Jun 15, 2015 3:19 pm
There are a couple options for you at this point.

1- Rename the files on the Source Server and have your Monitor kick in again with the new file names.
2- Tweak your Project to generate a new file list once it makes the connection and retrieve what's there
3- Have your Project loop through the list and go retrieve each file individually instead of as part of a FileList var.

Either one of the three above should help you get the file(s)
Rick Elliott
Lead Solutions Consultant
(402) 944.4242
(800) 949-4696
2 posts Page 1 of 1